Kontrolējošie vārstiIn regulation section Socla offers a wide range of control valves but also different air control devices (air valves, pulsairs, injectors). Lai iegūtu vairāk informācijas, veiciet nospiedienu uz attēla vai produkta virsraksta. Detalizētu informāciju par izvēlēto produktu jūs varat iegūt, lejupielādējot tehniskās dokumentācijas failu. Pressure Reducing ValvesControls and maintains a constant preset reduced downstream pressure regardless of variations in downstream demand or upstream pressure. C101 | | | Valve reduces the pressure in networks of water distribution, irrigation or pump outlet. |
Highlights - Valve controls and maintains a preset reduced downstream pressure regardless of variations in demand and upstream pressure (the setting of downstream pressure is always below the upstream pressure)
- Approvals : ACS - WRAS
Tehnisko datu fails : C101.pdf
| | | | |
Altitude Valves Float OperatedControls the level of a tank. Maintains constant level by means of float tap regulation. C701 | | | It prevents from overflowing and maintains a constant level in the tank thanks to a float. |
Highlights - Openings and closings are very progressive (a few centimeters from the required level)
- Prefer the installation at the bottom of the tank or close to it
- Approvals : ACS-WRAS
Tehnisko datu fails : C701.pdf
| | | | |
Overpressure Protection, Discharge ValveInstalled for the protection against the excess of pressure. C401 | | | It will keep open as long as an overpressure exists and will drain the excess water to a tank or low-pressure zone. |
Highlights - Installed on a by-pass on the network to be protected, this valve will open as soon as the pressure reaches the set pressure
- It prevents the pump from hunting by maintaining a minimum pressure
- Equipped with check valves, it closes in case of backflow in the discharge system
- Approvals : ACS-WARS
Tehnisko datu fails : C401.pdf
| | | | |
Air ValvesTriple function air valves for clear water. Ductile iron casing, PA 6 (polyamid) spindle, stainless steel drain cock, NBR (nitrile) drain cock seal, large orifice seal in polyurethane or NBR (DN100). VE 320 | | | Automatically and continuously relieves air and gases that accumulate in high points of installations. |
Highlights - Release or inflow of air through the large air orifice when filling or emptying the installation
- Epoxy coating inside/outside
- The stop valve allows the maintenance without emptying the installation
Tehnisko datu fails : VE320.pdf
| | | | |
Overpressure ProtectionSafety valve to protect pipe systems from water hammering. Cast iron or C-steel cap, C-steel flange, polyurethane seal, steel spring. AB 900 | | | The mechanism consists of a spring which is adjustable to the correct weight to hold the valve firmly in place against the seat, keeping it watertight. |
Highlights - For protecting the pipes against overpressure, (water hammering), whatever its origin, by evacuating the water in excess straightaway
- When a pressure wave occurs, this causes compression of the spring and the opening of the valve to allow evacuation of the water
- It should be noted that the stem is designed to compensate for defect of alignment which could be caused by hydraulic pressure on the valve and by the force of the spring
Tehnisko datu fails : AB900.pdf
| | | | |
OptionsOption 1- Pressure gauges with purge taps (10 bar, 16 bar, 25 bar). Option 1 | | | SIA Inducont offers Option 1- Pressure gauges. |
DN: 1"1/2(F/F); 40 and 50; 65; 80; 100; 125; 150; 200; 250; 300.
| | | | |
Citi šī ražotāja produkti |